Advertisement
DIMENSIONS / MOUNTING
The electronics is located in the front cover, which can be easily snapped on/off once the back cover is fixed onto the wall (D = moun-
ting holes) and wired.
EU version
85 / 3.35"
79.7 / 3.14"
4 / 0.16"
38.2 / 1.5"
CONNECTION DIAGRAM
Important note:
The manufacturer cannot be held responsible for personal injuries or damage to property as a result of incorrect handling,
installation, wiring, power supply and maintenance of the device.
EE800 VOLTAGE OUTPUT
configuration
connector
OPENING THE ENCLOSURE
Press to release the latch A till the enclosure can be opened. Use a
screwdriver or a pen.
CLOSING THE ENCLOSURE
Set the front cover into flute B, rotate it like C and press it onto the
back cover till the latch A snaps in.
IMPORTANT
In order to protect the front cover and the electronics from typical
construction site pollution (such as painting of the walls) the front cover
should be snapped on only after the construction works are completed.
As EE800 is generally mounted onto a conduit box, for accurate
measurement results it is important to tighten the conduit box for
avoiding false air ingress (along the electrical tubes inside the wall)
into the EE800 enclosure.
US version
*
*
Output: 0-5 V
85 / 3.35"
79.7 / 3.14"
60 / 2.36"
38.2 / 1.5"
8 / 0.31"
0-10 V
Advertisement
