Cleaning And Care; Safety Lock; Overload And Overheating Protection - Panasonic MX-EX1031 Operating Instructions Manual

Blender jug prewash
Containers and other parts
Wash each part in cold or lukewarm water with a soft sponge.
Carefully clean blades with a brush.
Rinse and dry thoroughly.
(Brush is not provided.)
The safety lock has been designed to prevent the blender from
switching on when blender jug or mill container is not properly in place.

Overload and Overheating Protection

In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
1
Turn the rotary switch to "0" position, unplug the appliance.
2
Remove blender jug or mill container from motor housing.
Reduce the ingredients to less than half. (For blender jug, it also can add liquid.)
3
Reset the blender jug or mill container, start blending again.
If the appliance still does not operate after performing the above, overheating protection has been activated.
Turn the rotary switch to "0" position, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a
normal temperature) to release overheating protection before using again.
(If appliance still does not operate, contact Panasonic Service Centre for inspection or repair.)

Cleaning and Care

Carefully clean blades with a brush. Do not use water.
(Brush is not provided.)
Wipe motor housing with a damp cloth.

Safety Lock

Storing
Mill container base
Motor housing
EN7