Parts Names And Instructions; Overload And Overheating Protection - Panasonic MX-MG5351 Operating Instructions Manual

Parts Names and Instructions

Blender
Blender Gasket
Blender Blade
Control
Motor
Illustrations of product in this
The Safety Lock has been designed to prevent the appliance from switching on when blender jug or mill container is not properly in place.
Note:
• Do not push the Safety Lock Pin and any Safety Levers with any instrument such as stick.
• Do not pour liquids or ingredients at the Safety Lock Pin and Control Panel area.
• Keep the Safety Lock Pin and Safety Lever area clean to avoid foreign particles accumulating in the area.

Overload and Overheating Protection

In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
1
Press "0" button, unplug the appliance.
2
jug, it also can add liquid.)
3
Reset the attachment, then start again.
If the appliance still does not operate after performing the above, overheating protection has been activated.
Press "0" button, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a normal temperature) to
release overheating protection before using again.
Wet & Dry Mill
MX-MG5351 Glass
Mill Container
Mill Gasket
Mill Blade
Mill Container Base
Control Panel
Ice Crush
Crush
EN5