Cleaning And Care; Safety Lock; Overload And Overheating Protection - Panasonic MX-EX1011 Operating Instructions Manual

nplug the appliance efore cleaning.
Clean the parts thoroughl after ever use. eep all parts clean and dr alwa s.
Do not wash an part of the appliance in the dishwasher.
Do not use enzine, thinner, leach, alcohol, n lon face of sponge, metal rushes or polish powder etc.
Some discoloration of the plastic parts ma occur upon usage ut it does not affect usage.
Blender jug prewash
Add 400 mL clean water into the lender ug, plug in and lend for a out 1 minute.
Blender jug and mill blade
Wash each part in cold or lukewarm water with a soft sponge.
Rinse and dry thoroughly.
Remove the mill gasket efore washing.
Around the lade, carefull clean with a rush under running
water. (Brush is not provided.
Storing
Assem le the mill container ase with the mill container.
Dr the lid thoroughl , then keep it separatel .
The safety lock has been designed to prevent the blender from
switching on when blender jug or mill container is not properly in place.

Overload and Overheating Protection

In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
Do not use the appliance repeatl without an countermeasure.
1
Turn the rotary switch to 0 position, unplug the appliance.
2
Remove blender jug or mill container from motor housing.
Reduce the ingredients to less than half. (For blender jug, it also can add liquid.)
Remove the prohi ted ingredient if used.
3
Reset the blender jug or mill container, start blending again. (P. EN6
If the appliance still does not operate after performing the above, overheating protection has been activated.
Turn the rotary switch to 0 position, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a
normal temperature) to release overheating protection before using again.
(If appliance still does not operate, contact Panasonic Service Centre for inspection or repair.

Cleaning and Care

Safety Lock

Other parts
Wash each part in cold or lukewarm water with a soft sponge.
Rinse and dry thoroughly.
Motor housing
Wipe motor housing with a well wrung-out cloth.
Safet lock pin
EN7