Table of Contents
Advertisement
Keyboard Control Speed: Define the speed of PTZ control by a keyboard as Low, Medium
or High.
Auto Scan Speed: The scan speed can be set from level 1 to 40.
ax. Tilt-angle: Set the tilt-angle of the speed dome from the dropdown list.
M
Zooming Speed: The zoom speed is adjustable from level 1 to 3.
PTZ OSD: Set the on-screen display duration of the PTZ status.
Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds, 10
seconds, NC (Normally Closed), or NO (Normally Open).
PT Status: Set the azimuth angle display duration while panning and tilting as 2 seconds,
5 seconds, 10 seconds, NC (Normally Closed), or NO (Normally Open).
Position Display Format: Set the position display format as PT or Direction and the
position parameter displays in corresponding format.
Preset Status: Set the preset name display duration while calling the preset as 2 seconds,
5 seconds, 10 seconds, NC (Normally Closed), or NO (Normally Open).
Power-off Memory: The speed dome can resume its previous PTZ status or actions after it
restarted from a power-off. You can set the time point to which the dome resumes its PTZ
status. You can set it to resume the status of 30 seconds, 60 seconds, 300 seconds or 600
seconds before power-off.
3. Click
5.4.2 Configuring PTZ Limits
Purpose:
The speed dome can be programmed to move within the configurable PTZ limits (left/right,
up/down).
Steps:
1.
Enter the Limit configuration interface:
Configuration > PTZ > Limit
© Hikvision
to save the settings.
Advertisement
Table of Contents
