Welch Allyn Spot VS100 Basic Instructions page 14

WARNING Liquids can damage electronics inside the vision screener. Prevent liquids from spilling on
the vision screener. If liquids are spilled on the vision screener:
1. Power down the vision screener.
2. Disconnect the power plug.
3. Dry off excess liquid from the vision screener. If liquids possibly entered the vision screener, remove
the vision screener from use until it has been properly dried, inspected, and tested by qualified service
personnel.
Clean the Vision Screener
Clean on a routine basis according to your facility's protocols and standards or local regulations.
The following agents are compatible with the vision screener:
• 70 percent isopropyl alcohol: Wipe the vision screener with a clean cloth slightly dampened with 70
percent isopropyl alcohol.
• 10 percent chlorine bleach solution:
1. Wipe the vision screener with a clean cloth slightly dampened with a 10 percent
bleach and water solution. Follow the cleaning agent manufacturer's guidelines.
2. Rinse with a clean cloth slightly dampened with water that meets EP and USP quality
standards.
3. Allow the vision screener surface to dry for a minimum of 10 minutes before using
the vision screener.
Disinfect according to your facility's protocols and standards or local regulations.
WARNING Electric shock hazard. Before cleaning the vision screener, disconnect the DC
power cord from the power outlet and the vision screener.