Quantum Q-LOGIC 3 Programming Manual page 19

WARNING!
Q-Logic 3 Controller and Quantum Seating system can
be programmed to ensure a safe and comfortable level
of tilt and recline in the position of the seating system.
The tilt and recline position can be adjusted as needed
to accommodate the end user's specific circumstances
and needs.
Although this manual outlines the adjustments, at
no time should the drivable seat angle exceed 25
degrees. Exceeding this setting may create instability or
unexpected loads on the seating system. Programming
or exceeding the inhibits may cause a compromise of
the integrity of the seating system which may result in a
fall leading to personal injury and/or death.
If your power chair is equipped with a reclining
seatback, do not attempt to negotiate inclines with the
seat in a reclined position. Do not attempt to negotiate
obstacles with the seat in a reclined position unless an
attendant is present to help stabilize the chair. Failure to
heed this warning may result in inadequate/inaccurate
programming and may result in instability, product
damage, and dangerous situations that may lead to
serious personal injury and/or death.
Seat Programming — Latched (Econ-W)
If the end user wants to latch an actuator, meaning that they
give the command and then the actuator will activate for the
set amount of time in the Timeout section.
1. Click on the Seat icon.
2. Click on Functions.
3. Find the actuator you wish to latch and check the box
next to it.
4. Set the Timeout above to the time you wish for the
actuator to operate.
5. After the changes are made, click on the Save icon.
Figure 6. Seat Programming—Latched (Econ-W)
SEAT 19