Quantum Q-LOGIC 3 Programming Manual page 13

Programming Sip N Puff — Changing Profile
with Double Command
To assign a profile change with either a double sip or double
puff follow these steps:
1. Parameter Settings/Program Adjustments
2. Sip N Puff
3. Device Options/Timing
4. Mode Command set to either:
„
Double Sip
„
Double Puff
From the Device Options/Timing section, you can also set
the Double Command Time and Long Command time via
slide bars. Using Double Sip or Double Puff will delay a
driving response from a stopped position.
Programming Sip N Puff — Changing Profiles
with Standby Select
Standby Select can be set for a certain length of time. When
that time expires, the power chair goes into a standby mode.
Standby mode then reverts to the home screen, where the
end user can choose which part of the chair they want to go
into, such as Settings, Drive or Seat.
1. Parameter Settings/Program Adjustments
2. Sip N Puff
3. Standby Select
„
Enabled
4. Standby Select Timeout
„
Use the Slide Bar in the time out box to set the time
The Standby Seat and Aux Timeouts if disabled an
alternate mode method must be available.
Programming Switched Turning Adjustments
Switched Turn allows the speed and tightness of the turn to
be adjusted to the individual you are working with.
1. Parameter Settings/Program Adjustments
2. System
3. Shaping Settings
„
From here you can adjust each parameter individually
per profile setup.
SIP-N-PUFF 13