Table of Contents
Advertisement
10 - MENU STRUCTURE
The following chart describes the MENU tree of the product, the terms shown in BOLD indicates the
default settings.
1
CONNECT
ADDRESS
DMX MODE
WIRELESS
ETHERNET
SETTING
2
SET UP
SCREEN
DMX / WDMX
VALUE (1-512)
sACN
ARTNET
BASIC
STANDARD
EXTENDED
WDMX ON/OFF
ON/OFF
TRANSMITTER/
WDMX MODE
RECEIVER
TX LINK
ON/OFF
TX UNLINK
ON/OFF
RX RESET
ON/OFF
ON/OFF
DMX TO WDMX (TX)
ON/OFF
WDMX TO DMX (RX)
ARTNET SETTINGS
IP ADDRESS
NET
SUBNET
UNIVERSE
sACN SETTINGS
IP ADDRESS
UNIVERSE
MERGE MODE
ON
ETHERNET TO DMX
OFF
BACKLIGHT
ON/10S/20S/30S
FLIP DISPLAY
ON/OFF/AUTO
PROLIGHTS - Astra Profile400
Set address used for Fixture.
Set DMX chart for Main Fixture.
Enable/Disable the wireless card.
Allows to choose whether to set the wireless
on the Transmitter or Receiver.
WDMX mode is unlocked only if WDMX ON
/ OFF is ON.
TX link unlock when the unit is set as a
transmitter.
Disconnect the transmitter from all receivers.
TX unlink unlocks only if WDMX mode is on
transmitter
Total reset of the receiver.
RX reset unlocks only if WDMX mode is
receiver.
Enable/Disable the transmission of the DMX
values via wdmx.
Main Fixture to WDMX: transmitt main
fixture DMX values
Pixel Engine to WDMX: transmitt pixel
engine dmx values
Enable/Disable the retransmission of the
DMX from the receiver to the other units
connected by cable to the receiver itself.
Set IP address of the fixture.
Set Net for ArtNet protocol. (Default 0)
Set Subnet for ArtNet protocol. (Default 0)
Set Universe for ArtNet protocol. (Default 0)
Set IP address of the fixture.
Set Universe for sACN protocol. (Default 1)
Set Merge Mode for sACN protocol. (Default OFF)
Enable / Disable DMX retrasmission from
sACN/ArtNet signal to DMX out port.
Allows you to select the timing after that
display will switch automatically off when
unactive.
Allows you to rotate the display by 180°.
15
Advertisement
Table of Contents
