Table of Contents
Advertisement
•
Button inputs: Configuration as actuator button, bust button or for zero position
sensor (see Button inputs (drives), page 35)
Settings for switch functions
(Channel is divided into two switches A1|A2):
•
General specifications for the switch function
(see Channel settings – switch functions, page 44)
•
Connecting different communication objects
(see Connection (switch functions), page 45)
•
On/Off switch delays or time switching
(see On/Off switch delays, time switching (switch functions), page 45)
•
Block function(see Blocking function (switch functions), page 46)
•
Button input: Configuration as actuator button or bus button
(see Button input (switch functions), page 46)
5.2.1. Channel settings – drives
If a drive is connected to the output channel, set first the general specifications for the
drive.
Driving direction:
Up/down, on/off or open/close can be exchanged.
Exchange UP/DOWN (shutter, blinds)
Exchange RETRACT/EXTEND (awning)
Exchange OPEN/CLOSE (window)
Runtime:
The runtime between the end positions is the basis for moving into intermediate
positions (e.g. for movement range limits and scenes). Enter the runtime numerically
(in seconds).
Runtime DOWN in sec (shutter, blinds)
Runtime EXTEND in sec (awning)
Runtime OPEN in sec (window)
Runtime UP in sec (shutter, blinds)
Runtime RETRACT in sec (awning)
Runtime CLOSE in sec (window)
If a dead time is observed while starting the curtain, then this can be entered manually
at this point or calculated automatically. Obey the manufacturer's instructions for the
curtain.
Use dead times
during the position travel from closed
position in 10 ms (only for manual input)
for position movement from all other
positions in 10 ms (only for manual input)
Actuator KNX S1R-B4 compact • Version: 12.09.2022 • from application 1.0 • Technical changes and errors excepted.
15
no • yes
1 ... 320; 60
1 ... 320; 65
• no
• yes, enter by hand
0 ... 600
0 ... 600
Parameter setting
Advertisement
Table of Contents
