Parameter Setting; General Settings; Output; Channel Settings - Drive - elsner elektronik KNX S1R-B4-UP DES Installation And Adjustment

6.

Parameter setting

The default settings of the parameter are labelled by an underscore.

6.1. General settings

First set the general parameters for the bus communication (telegram rate,
transmission delay). Additionally, you can indicate if for the programming of scenes
all, or only the changed settings are applied to the bus.
Maximum telegram rate
Send delay of threshold values
after voltage returns
Send delay of switching and status
outputs after voltage returns
For the use of scenes:
Application when programming

6.2. Output

• General specifications for the connected drive
(see Channel settings – drive, page 15)
• Control functions: Movement range limit, blocking, type of automatic
(see Control, page 16)
• Automatic functions: Automatic can be specified externally or internally
(see Automatic - internal for shading:, page 22)
• Scenes: Movement positions (see Scenes, page 27)
• Button inputs: Configuration as actuator button, bust button or for zero position
sensor (see Button inputs, page 27)
6.2.1. Channel settings – drive
Set the general specifications for the drive.
Runtime:
The runtime between the end positions is the basis for moving into intermediate
positions (e.g. for movement range limits and scenes). You can enter the runtime
numerically here (in seconds).
Use an automatic runtime measurement
Runtime UP in sec
Runtime DOWN in sec
Actuator KNX S1R-B4-UP DES • Version: 27.05.2020 • from application 1.0 •
15
1 • 2 • 5 • 10 • 20 telegrams per second
5 s ... 2 h
5 s ... 2 h
all parameters • only changed parameters
no • yes
1 ... 320; 65
1 ... 320; 60
Technical changes and errors excepted.
Parameter setting