Package Opening - BWT AQA drink Ho.Re.Ca. General Instructions Manual

If the mains cable is damaged, it must be replaced by the dealer or BWT ITALIA Srl's technical service department in order to
prevent any risk.
Do not crush the power cable or place heavy objects on it.
Do not use adapters to connect the device to the electrical outlet.
Do not pull the plug from the power socket with wet or damp hands.
Do not pull the power cord or the appliance to unplug it from the electrical outlet.
In case of anomalies (water leakage or other), disconnect the power supply and position the valves so that the appliance is in
by-pass.
Do not use the appliance in explosive environments.
The appliance must always remain electrically powered.
Do not climb or sit on the appliance.
Only use original accessories.
Never immerse the appliance in water.
Do not clean the appliance with water jets.
Carry out all start-up, cleaning or maintenance operations with the appliance switched off, no water supply and the mains plug
disconnected from the 230V 50Hz socket.
If the appliance is used inappropriately, not in accordance with the instructions for use, or if it is tampered with, the manufacturer
shall not be liable for any damage caused to persons, animals or property.
When the appliance is scrapped, it must be rendered unusable and then disposed of in accordance with current regulations.
When positioning the machine, ensure that the supporting surface is adequate for the weight of the machine itself.
The manufacturer accepts no liability in the specific cases described below:
improper use of the appliance;
use contrary to specific national regulations (power supply, installation and maintenance);
installation by unauthorised personnel;
power supply faults (electrical discharges, power surges, water mains overpressure, low water pressure);
unsuitable ambient operating temperature;
lack of planned maintenance;
unauthorised modifications or interventions;
use of spare parts that are not original or not specific for the model;
total or partial non-compliance with the instructions.
HYGIENE/SANITARY PRECAUTIONS
For hygienic reasons, during maintenance, do not touch the internal parts of the appliance without first carrying out the
normal hygiene procedures.
If the appliance has been switched off for more than 24 hours, dispense at least 5 litres of water (depending on requirements
and water quality).
If the appliance has not been switched off for more than 24 hours, dispense at least 2 litres of water before consumption. The
appliance must be used in full compliance with hygiene regulations to ensure water quality.
PACKAGING

PACKAGE OPENING

The luminaire is generally shipped on a pallet protected in a cardboard box and with plastic film: polyethylene bag and bubble
wrap. In addition, the stainless steel panelling is protected by suitable, easily removable plastic film.
The packaging can be removed before taking the appliance to the installation site to await the technician. The packaging must
be opened from the top. Remove the adhesive tape and closing straps.
Avoid damaging the surface of the stainless steel or painted panels depending on the model of the appliance. It is advisable
to keep the packaging for future use. Once the packaging has been removed, check that the appliance has not been damaged
during transport. If this is the case, contact your dealer. Check the presence of the accessories supplied, which must be contained
inside the box. The manufacturer reminds you that the warranty does not cover damage caused by transport or unloading and
handling. Do not leave packaging materials unattended as they are potential sources of danger. If necessary, dispose of them in
accordance with local regulations in force.
CONTROL OF GOODS
After removing the packaging, check that the machine has not been damaged during transport. If this is the case, contact your
dealer. Check the presence of the accessories that must be contained inside.
A Q A d r i n k H o . R e . C a .
5