To Use A Usb Connection - Honeywell HON-CGW-MBB Installation And User Manual

Gent Panels
3. Power Connection
NOTE: The external power supply must be dedicated and not shared with any other
devices.
NOTE: The panel's power supply to the gateway must be within +24V DC power.
On the Gateway Side
1. Connect to the 24V DC external power supply.
2. Ensure that the S7 switch next to the RS-232 port is switched towards NUP_OUT.
On the Panel Side
Connect the power cable into the 24V DC external power supply.

To Use a USB Connection

1. On the Gateway Side
Connect the USB-C side of the cable to the USB port of the gateway.
The USB port is labeled as 8 in the figure
2. On the Panel Side
In the MCC card on the panel:
Connect the USB-B side of the cable. Refer to the figure
3. Power Connection
Connect the gateway to a 24V DC external power source.
NOTE: The external power supply must be dedicated and not shared with any other
devices.
NOTE: The panel's power supply to the gateway must be within +24V DC power.
CLSS Gateway - Installation and Users' Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022
Figure C.21: The S7 Switch
Figure C.2.
Connecting to the Panels
Figure C.20.
134