C.5: Farenhyt Panels; C.5.1: Connection Options; C.5.2: To Use An Rs-485 Connection - Honeywell HON-CGW-MBB Installation And User Manual

Connected life safety services clss gateway
Table of Contents

Advertisement

Farenhyt Panels
C.5 Farenhyt Panels
C.5.1 Connection Options
The gateway operates only with the Farenhyt fire alarm control panels as listed in the
table below:
CAUTION: WHEN SUPPORTING THE ALARM TRANSMISSION, IT IS RECOMMENDED THAT THE
!
FARENHYT PANEL SHOULD USE SECONDARY ANN BUS CHANNEL WITH CLASS A WIRING.
IF THE ALARM TRANSMISSION SERVICE IS NOT USED, THE PANEL CAN USE EITHER THE PRIMARY OR
THE SECONDARY ANN BUS CHANNEL FOR THE CLSS GATEWAY CONNECTION.
Minimum Required Versions
For the CLSS Gateway: 3.1.4.74
C.5.2 To Use an RS-485 Connection
Using an RS-485 cable the CLSS Gateway connects with the annunciator primary
terminal of the panel.
CAUTION: CONNECT EITHER THE CLSS GATEWAY OR THE ANN S/P G MODULE WITH THE PANEL. BOTH
!
OF THEM SHOULD NOT BE CONNECTED TOGETHER WITH THE PANEL.
1. On the Gateway Side
At the RS-485 A port in the gateway board:
• Connect the A connector to the IN+ pin of the RS-485 A port.
• Connect the B connector to the IN- pin of the same RS-485 A port.
The RS-485 ports in the gateway board are labeled as 3 and 4 in the
2. On the Panel Side
At the S-BUS board in the ANN-BUS PRI terminal:
• Connect the RS-485 +ve wire to the A port.
• Connect the RS-485 -ve wire to the B port.
3. Power Connection
On the Gateway Side
In the power supply port (labeled 7 in the
• Connect the Red wire to the +24V pin.
• Connect the Black wire to the Gnd pin.
CLSS Gateway - Installation and Users' Manual | P/N:LS10248-000HW-E | REV. F | FEB/11/2022
Table C.3: Farenhyt Panel Connection Options
Fire Alarm Panel Models
Panel firmware version: 6.05.01
IFP-75
IFP-300
IFP-300ECS
IFP-2100
IFP-2100ECS
Panel firmware version: 5.0
IFP-50
IFP-100
IFP-100ECS
IFP-1000
IFP-1000ECS
IFP-2000
IFP-2000ECS
RS-485
UART/TTL
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Yes
No
Figure
C.2):
Connecting to the Panels
RS-232
USB
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
No
Figure
C.2.
117

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents