Software Configuration; Testing The Connection; Checking Wireless Signal Strength - Thermo Scientific Smart-Vue Installation Manual

Software
configuration

Testing the connection

Checking wireless signal
Thermo Fisher Scientific
When activating your Smart-Vue end-point module as described in the
previous section, the device adds itself to your current Smart-Vue
Server/Smart-Vue Client configuration.
You may use Smart-Vue Client to test the wireless signal strength as
strength
described here, entering your login name and password when prompted by
the software.
1. Launch Smart-Vue Client on your computer and enter your login
name and password to continue.
2. Select Settings ==> Sensor settings or press F11.
3. Click on Add/Update an end-point module.
4. Select your receiver in the drop-down menu ("local" in Figure 6),
and then select the wireless module from the sensor list on the left.
Figure 6. Configuration with the Smart-Vue 4-20 mA end-point module
5. Click on Power to test the connection. You may also click on
Initialize and Current sensor measurement, and Synchronize
end-point module clock to confirm proper operation. Click on
Close to exit the screen.
on receiver "local"
Smart-Vue 4-20 mA Module Installation Guide

Software configuration

13