Thermo Scientific Smart-Vue Installation Manual page 19

Thermo Fisher Scientific
4. Create an active group by clicking on the receiver name ("local" in
this example) to Create group, and then enter the group name
("Group_1" in this example). Click on OK to continue.
5. Drag the new sensor from the "SDP-local" group to the group you
just created:
Figure 8. Move sensor from the generic "SDP" group to your active
group
6. Click on Close ==> Yes ==> OK to update the end-point module,
save this change, and return to the tree structure, as shown below:
Figure 9. 4-20 mA sensor in the ""Group_1" group
Smart-Vue 4-20 mA Module Installation Guide
Software configuration
15