Hardware; Led Indications; Figure 38: Leds; Table 2: Pwr And Ird Led Functions - NAL RESEARCH CORPORATION QUICKSILVER QS-100 User Manual

7 H
ARDWARE
7.1 LED I
NDICATIONS
For the first approximately 15 seconds after power-up, all of the LEDs will be solid. Then they
will begin functioning according to the tables below.
NOTE: Wait at least between 20 to 30 seconds after turning off the device before
turning it back on.
Power (PWR)
State Description
Off Device off
* Double Recovery mode
Blinking
Blinking Starting up
Rapid In safe mode using default configuration due to
Blinking startup error
Solid Startup successful
* To recover your device from this state, contact NAL Research Tech Support by dialing +1-888-
SHOUT-NR (+1-888-746-8867) or mailing support@nalresearch.com.
Document Number: 451-19004-001C

Figure 38: LEDs

Table 2: PWR and IRD LED Functions

Quicksilver QS-100 User Guide – Revision C
Iridium (IRD)
Description
Iridium disabled or
signal 0
N/A
Iridium signal 1-2
N/A
Iridium signal 3-5
48 of 74