Table of Contents
Advertisement
Quicksilver QS-100 User Guide – Revision C
Figure 4: Quicksilver Wall Adapter
2.2
P
O
/O
& A
, R
OWER
N
FF
WAKEN
EBOOT
Activate the Quicksilver by providing 10 – 32 VDC power to the power pins on the DB-25
connector or plugging in the wall adapter provided with the Quicksilver Data Adapter. Once
power is applied, the Quicksilver begins the startup process. All five LEDs illuminate solid for 15
seconds and then go into the indication modes described in section 7.1 LED Indications.
Turn off the Quicksilver by removing the 10 – 32 VDC power from the power pins on the DB-25
connector or unplugging the wall adapter provided with the Quicksilver Data Adapter.
Document Number: 451-19004-001C
17 of 74
Advertisement
Table of Contents
