Table of Contents
Advertisement
5.4
E
THERNET
The Ethernet page displays the current interface and DHCP configuration on the Ethernet
network (see Figure 28).
5.4.1
G
ENERAL
IP Address — Configures the default gateway of this network. It must be a valid IPv4
address. It must not belong to the same network defined in the Wi-Fi menu.
CAUTION:
If the user changes the address for accessing the configuration website, the
connection will be dropped and a new connection must be made to the new address.
Subnet Mask — Configures the netmask. It must be a valid IPv4 netmask.
5.4.2
DHCP
The following settings configure the dynamic host configuration protocol on this network. Any
changes to the general settings should be accompanied by an appropriate shift in the
configured DHCP ranges. The default range allocates 150 addresses.
Document Number: 451-19004-001C
(A
O
)
DMIN
NLY
Figure 28: Ethernet Page
Quicksilver QS-100 User Guide – Revision C
37 of 74
Advertisement
Table of Contents
