Figure 33: Add New Rule Window - NAL RESEARCH CORPORATION QUICKSILVER QS-100 User Manual

 Position — Indicates where the new rule will be inserted. If referencing another rule,
the new rule will be inserted above it.
 Name — The name of the rule, which must be 1-15 characters and only contain
alphanumeric characters, '_', '-', '.', and '~'.
 Protocol – Any, ICMP, TCP, or UDP.
 Address — A destination address to associate with this rule. Can be any address, a
single address, or a subnet of addresses defined in prefix format. This address can also
be negated (as in: match all addresses EXCEPT what is specified). Must be a valid IPv4
address.
 Action — The action to take once a packet matching the rule has been processed.
Options available are block or allow.
Document Number: 451-19004-001C

Figure 33: Add New Rule Window

Quicksilver QS-100 User Guide – Revision C
43 of 74