Recharging The Battery - Nortel IP Phone 2210 User Manual

Recharging the battery

Follow this procedure to recharge the battery pack. The handset can be
recharged when in a power off or standby state.
The indicator light on the Desktop Charger lights only when the handset is
inserted correctly into the connector. If the light does not turn on, check to see
that you correctly inserted the handset and that the charger is connected to a
power source.
It is normal for the battery pack to warm up when it is recharging.
Prerequisites
You must have the Nortel Networks WLAN Handset Desktop Charger
appropriate for the model of handset.
Attention:
— To charge the battery pack, always use the Desktop Charger provided. Other
chargers can damage the battery pack.
— Use only the original plug-in power adapter provided with the unit.
Procedure steps
Step
1
2
3
Copyright © 2006, Nortel Networks
- 102 -
Use the handset battery pack
Action
Press the Power Off/End Call key. Hold the key down for two seconds
if you want to transition to the power off state.
Place the handset face-forward into the Desktop Recharger.
The red indicator light turns on. If the handset is in standby mode, the
handset extension number and
If the handset is off, the extension number does not appear.
Recharge the battery.
The battery is fully charged when
display area. The indicator light stays lighted as long as the handset
is connected to the recharger.
Carrier VoIP
Nortel IP Phone 2210, 2211, 2212 User Guide
NN10042-116 01.03 Standard
(I)SN09U October 2006
appear in the display.
Charging...
Charge Complete
--End--
Nortel Networks Confidential
appears in the