09/09 Rev. 5.03-01
Punch sensor
Transmission sensor, adjustable from the left side about half of the material
width (0-60 mm) [2].
[Tab. 3] Required punch measures.
Reflex sensor
[2] Measures and setting range of the punch / reflex mark.
Max. print length
The maximum print length depends on the following:
Zero line
Offset of the material zero line to the print zero line: 1 mm
Fonts
Modifying Fonts
USER / SERVICE MANUAL
AP 4.4 – AP 5.4
Sensor type
Transmission sensor
(Standard)
Reflex-sensor
(optional)
•
The reflex sensor for AP 5.4 is optionally available (for reflex marks on the
material underside)
•
Adjustable from the left side about half of the material width (6-66 mm)
•
The dark/light change at the reflex sensor is taken as the label beginning
(= end of the reflex mark)
Punch sensor
•
Printer type
•
Printer resolution
•
Firmware version
•
Parameter settings (e.g.
•
17 Fixsize fonts , including OCR-A and OCR-B
•
3 scalable fonts (Speedo fonts)
•
Truetype fonts are supported
•
Optionally can Truetype, Speedo and Fixsize fonts be stored on a CF-card
•
Up to factor 8 scaling in x/y direction
•
Rotation by 0, 90, 180 and 270 degrees
Setting range
Punch length
(Size c)
(Size b)
0–60 mm
0,8–14 mm
4 mm
6–66 mm
(recommended)
Punch / Reflex mark
a
c
b
SYSTEM PARAMETERS > Free store
Specifications
Punch width
(Size a)
min. 4 mm
12 mm
(recommended)
Label web
size)
5