Inta IT1007CP Nstallation And Maintenance Instructions page 2

Introduction
This installation guide has been produced for the Intatherm safe touch thermostatic basic mixer
tap. These instructions cover the installation, operation and maintenance. Please read the
enclosed instructions before commencing the installation of this product, please note;
We recommend that the installation of any Inta product is carried out
by an approved installer.
The installation must be carried out strictly in accordance with the Water Supply (Water Fitting)
Regulations 1999 and any local authority regulations.
If in doubt we recommend that you contact WRAS - Water Regulations Advisory Scheme on
Tel: 0333 207 903, your local water authority - details available on the WRAS website or the
Chartered Institute of Plumbing and Heating Engineers on Tel: 01708 472 791.
All products MUST be re-commissioned to suit site conditions to ensure optimum performance
levels of the product are obtained.
It is recommended, especially in hard water areas, that a water conditioner such as the
ActivFlo be fitted to reduce the risk of calcium deposits forming.
Safety
The Intatherm safe touch basin mixer tap contains an integral thermostatic
cartridge to prevent scalding.
This thermostatic mixer tap must be installed and commissioned correctly to ensure that water is
supplied at a safe temperature to suit the users.
43˚C is the maximum mixed water temperature from a mixer tap. The maximum
temperature takes account of the allowable tolerances inherent in thermostatic mixer taps and
temperature losses.
It is not a safe washing temperature for adults or children.
The British Burns Association recommends 37 to 37.5˚C as a comfortable washing
temperature for children. In premises covered by the Care Standard Act 2000, the maximum
mixed water outlet temperature is 43˚C.
Products
Intatherm safe touch basin mixer tap with copper tails
Check Content
Before commencing remove all components from packaging and check each component with
the contents list.
Ensure all parts are present, before discarding any packaging. If any parts are missing, do not
attempt to install your Inta tap until the missing parts have been obtained.
© Intatec Ltd 2022
1
IT1007CP