Advertisement
NOTE: The 4x6,5x6, 6x12 rooms have a one-piece side wall system,
and the 4x5, 5x7, 7x10 rooms have a two-piece side wall system.
The process is the same for the one or two-piece systems.
NOTE: For ease of installing the panels, tilt the top of each panel
back to get the tongue and groove alignment started. Then tilt
forward for an easy fit.
6. Secure the 2 corner wall panels with three 3" Torq screws
(provided). Install one screw on the top of the wall, one in the
middle, and one on the bottom. Ensure the tongue and groove
wall boards are tight together at the interior corner of the sauna
and the corner is flush on the outside edge when screws are
installed.
7. Ensure that the two corner wall panels are flush for the entire
length (base to top) and locate the pre-drilled holes and use the
supplied 3" screws to secure the two panels together.
8. Continue to install each wall panel with the corresponding base
number staring from your initial corner and working around the
room.
9. Make sure that the wall panels are flush at the top and seated into
place at the bottom. Ensure the tongue and groove are fully
engaged between each panel.
10. First ensure tongue and groove are fully engaged. Then secure the
2 back wall panels together with a 3" screw where the panels meet
on top.
11. Continue installing the next panel in the number series, being
careful not to damage the tongue & groove pieces of the panels.
Remember to angle the wall panels and then slide them into place
so that the length of the tongue is seated firmly and evenly into
the groove.
NOTE: A rubber mallet or wood block and standard hammer can
be used to make sure that the bottoms of each panel are even
with the corners of the base frame/floor perimeter. Be careful not
to damage the panels when using this technique.
71-0156
Rev. 03
Page 6
4215-136
10/21/2022
Advertisement
