Advertisement
Room with Return ("L-shaped") Bench
Note: The 5 x 7 room bench system has three benches (Upper Main
Bench, Upper Return Bench, Lower Main Bench). The upper main
bench and lower main bench
span from left to right walls. The upper return bench butts up to the
upper main bench and spans to the front wall.
55. Install upper return bench to the notch on the upper main bench
and the front wall bench support. Use the 3/8" bit to drill 2 holes
where the upper main and upper return benches meet. Bolt the
benches together using the carriage bolts provided.
Note: When aligning the return bench with the main upper bench,
make sure the bench tops are flush with each other.
Backrest Installation
56. Locate the backrest and remove the backrest mounting hardware
from the backside of the backrest. The longest backrest will be
installed on the back wall. If you have a return bench the other
backrest will be above the return bench.
57. Place backrest finished side down on the upper bench with the LED
light strip closest to the bench front. Next, connect the low-voltage
power cable from the back wall to the LED lighting strip end.
Connect the 12" LED jumper to the other end of the LED strips.
This will be used to connect the left backrest.
NOTE: Cut 2 pieces of wood to 8 3/8" to
use as a gauge block. Position them on the
upper bench to make installation of the
backrest easier.
58. Measure 20" from the top of the bench to
the top of the backrest. Making sure
backrest is level, fasten it to the wall through the predrilled holes,
using 2" screws (provided).
Note: If using gauge block carefully remove. Wood plugs are
provided to cover the exposed screw head.
Door Handle
59. Install door handle so the handle with the predrilled holes is in the
inside of room. Secure handle with two screws provided within the
handle package and cover screw heads with wooden buttons.
71-0156
Rev. 03
Page 13
Sauna Heater
Installation
4215-136
10/21/2022
Advertisement
