Finnleo Euro Outdoor Series Owner's Manual page 14

*Defer to heater manual for specific instructions.
60. A licensed electrician should wire the heater according to the
specifications provided with the heater. One of the wall panels has
a removable board to allow for wiring access to the heater. This
tongue and groove board is in the trim package. After the wiring,
attach the board with the brad nailer.
Wiring
*Defer to heater manual for specific instructions.
61. Depending on your heater and control selection for the sauna, you
may or may not need a low voltage connection box for the lights.
When using a SaunaLogic2 control, the lights are hooked up inside
the regular contactor box. Other heaters such as the Designer,
Vena and others may need this low voltage box for lighting hook-
up.
Rock Placement (Very Important)
*Defer to heater manual for specific instructions.
62. Rinse the rocks before placement in the sauna heater. Place the
smaller and flatter rocks around the outside of the rock
compartment and the larger rocks in the center. This allows good
air transfer through the heater. Do not try to force all the rocks in,
it is important to have space between the rocks.
Duck Board
63. Place duckboard (floorboard) on floor in front of the lower bench.
71-0156
Rev. 03
Page 14 4215-136
10/21/2022