Advertisement
INSTALLATION OF SAUNA ROOM
All wall panels will be numbered at the top and should be visible from the
interior of the room. These numbers will coincide with the numbers on
the base frame. NOTE: The tongue and groove on the panels will always
face the same direction
• E
ACH PANEL IS HEAVY
ESPECIALLY THE ROOF PANELS
• T
WO ADULTS ARE REQUIRED FOR THE INSTALLATION OF SAUNA ROOM
Base Installation
1. Position the base frame or Integral floor in the desired location on
a level surface. The largest number on the base frame is the
standard door location. The stamped numbers on the base frame
should be readable from inside of the room.
a. Standard base (rooms larger than 5x7): Fasten the corners
of the base frame using one 3" screw at each corner in the
predrilled holes. Predrilled holes are purposely made at an
angle.
b. Integral Floor (rooms less than 5x7): The base frame will be
built into the integral floor.
2. The base rail is numbered to correspond with the panels. Number
1 should be to the right of the door, couting up as you move
counter clockwise around the base.
3. Using a level and measuring tape, confirm the base frame is square
by measuring corner to corner. The dimensions should be the
same when the base is square. Shim where needed to level the
base.
Wall Panel Installation
4. Starting in a corner place the panel on the outer edge of the
corresponding floor panel. Slide the panel along the base frame
until framework is flush with the outside of the base frame.
NOTE: To help prevent rain, snow, and moisture, use silicone caulk
in between the base rail and walls as well as in between wall panel.
5. Hold the first panel in place and carefully lower the perpendicular
side wall corner panel into the base, starting at an angle and sliding
it into place. Slide it tight into the corner so framework is tight up
against the framework of the other panel.
71-0156
Rev. 03
. U
SE CAUTION TO AVOID INJURY WHEN INSTALLING
.
Page 5
,
.
Integral Floor
4215-136
10/21/2022
Advertisement
