Advertisement
Interior Cove Molding Installation
50. Using #4 finishing nails (Pneumatic nailer preferred), nail the cove
molding to the interior walls.
51. Secure the molding to the walls nailing it through the bottom &
into the ceiling to help keep it in place.
Bench Installation
In most cases the bench supports are pre-installed. If not, the interior
walls have been marked and labeled at the heights you should attach the
bench supports. Standard top bench support is 30" and lower bench
support is 12". These are the heights off the floor to the top edge of the
bench supports, not the top of the benches.
If not pre-installed follow these steps:
o Locate the bench supports. Install starting with the top
bench support first.
o Position the bench supports tight into corner. Making
sure they are level, use 3" screws and pre-drilled holes
to secure the bench supports to the walls. Be sure to
install screws in all the pre-drilled holes.
NOTE: One side of the bench is capped, while the others have
exposed framing. Benches should be installed with the capped side
facing forward
Note: The 4x5, 4x6, and 5x6 bench systems have two benches
which span from left to right walls.
52. Starting with the lower bench and sliding into place against the
back wall.
53. Place upper bench on upper bench supports.
54. Secure upper bench with two 3" screws through the framework
into the backwall and one 3" screw into right and left sidewalls.
Note: Secure the lower bench only in rooms with a return bench,
Lower benches with no return bench are designed to slide back
out of the way for ease of cleaning.
71-0156
Rev. 03
Page 12
4215-136
10/21/2022
Advertisement
