Audio - GeoVision GV-TBL Series User Manual

3.3.3 Audio

Note this function is only applicable to audio-supporting models.
You can configure the audio settings of the camera.

Audio Input: Select On to enable audio input.

Input Gain: Set the audio signal amplification for sampling. The greater the gain, the
greater amplification.

Audio Compression: Select an audio codec.

Noise Suppression: Select On to reduce the noise of the audio.

Channel 1 / 2: Click Enable to enable audio in through the camera's built-in microphone
and/or Audio In wire(s) depending on the model.

Audio Output: Select the source of audio output.
Note: For GV-TDR2700 / 4700, connection(s) to any software/application must be
reestablished when its audio input channel has been alternated for the change to take effect.
Figure 3-16
Administrator Mode
3
95