To Switch Between Two Calls; Hang Up While Conferencing; Transferring Calls; Attended Transfer - NEC DT900 Series User Manual

To switch between two calls

1
2
3
4
5

Hang Up while conferencing

•
•

Attended transfer

1
2
6-68
C A L L T R A N S F E R R I N G A N D C O N F E R E N C I N G
You cannot shuttle between calls after you have joined two calls in a
Note:
conference call.
While on a call, press the Conf softkey.
Use the key pad to dial the telephone number of the party to be joined in the conference.
Press the Dial softkey to initiate the call, or wait a few seconds for the call to be
automatically dialed.
After you have connected to the second call, press the Shuttle softkey to switch
between calls without joining them in a conference.
The LCD will display the information for call you are currently on.
To join the two calls into a conference, press the Conf softkey.
After you have joined two calls in a conference call, you can no longer use
Note:
conference shuttle since the calls are now in one single conference call.
E N D I N G C O N F E R E N C E C A L L S
If you are establishing a conference call and want to hang up on the person you are
calling, press the EndCall softkey.
If you hang up the telephone handset or press the Speaker key while the phone for
the new call is still ringing, the other two parties are connected in a blind transfer call.
Do not hang up the telephone handset or press the Speaker key unless you
Note:
want the two calls to be connected in a blind transfer call. You can hang up the
telephone handset or press the Speaker key after you connect with all the
callers.
To end a three party conference call, press the EndCall softkey or hang up the telephone
handset. You will disconnect from both parties, but they will still be connected with one
another until they each hang up their telephone.
T R A N S F E R R I N G C A L L S
Transfer operations cannot be completed if the person you are trying to
Note:
transfer the call to places you on hold, or if the call from you is placed in a held
state before the transfer operation completes. The operation fails and you
remain connected to the caller the same as before you started the transfer
operation.
An Attended Transfer is when you consult with the other party before transferring the
call. You connect the two callers, and you are then disconnected from the call.
While on a call, press the Transfer key.
This puts the current call on hold so you can start to transfer the call.
Use the key pad to dial the telephone number to which the call is to be transferred.
DT900/DT900S Series Phone User Guide