BorMann BPG9000 Manual page 7

Important: start spraying outside the surface to be sprayed and avoid stopping on the surface.
Right (fig.11)
Always hold the spray gun at an even distance of approx. 5-15cm from the object to be sprayed. Move the spray gun evenly
across or up and down, depending on the adjusted spraying effect. An even movement of the spray gun will give a uniform
surface quality
Wrong (fig.12)
Excessive paint mist formation uneven surface finish
If coating material builds up on the nozzle (2) and air cap (1) clean both parts with solvent or water.
Breaks in work
• Turn off device.
• Place spray gun in spray gun holder.
Closing down and cleaning
1. Turn off device. Open trigger so that the coating material in spray gun runs back into the container.
2. Unscrew the container. Return remaining coating material into the material can.
3. Clean the container and ascending pipe with a brush.
4. Fill the container with solvent or water.
Screw container back in place.
Only use solvent with a flash point of over 21°C.
Turn on device and spray the solvent or water into a container.
If a tube is not used, some solvent or water will be deposited outside the container.
This is due to the high air volume.
5. Repeat the above procedure until clear solvent or water comes out of the nozzle.
6. Turn off device.
7. Then completely empty the container. Always keep the container seal free of coating material and check for damage.
8. Clean the outside of the spray gun and container with a cloth soaked in solvent or water.
9. Unscrew the union nut. Remove air cap .Clean the air cap and nozzle with brush and solvent or water.
Note:
Never clean the nozzle or air hole of the spray gun with sharp metallic objects.
Technical Data
Voltage ~ Frequency
Power:
Spraying pressure:
Max flow:
Max. Viscosity:
Nozzle:
Container capacity:
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior
notice unless these changes significantly affect the performance and safety of the products. The parts described / illustrated
in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line
with similar features and may not be included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty
will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement
work, including maintenance and special adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
7
220-240v 50/60Hz
800w
0.1-0.3bar
1100ml/min
70/60din-s
φ2.5mm
900ml
www.BormannTools.com