BorMann BPG9000 Manual page 4

Function description
The motor blower produces a flow of air which flows through the air hose to the spray gun. The air flow atomizes the coating
material at the nozzle and also pressurizes the container. This pressure pushes the coating material up the ascending pipe to
the nozzle. The air and pressure setting can be adjusted progressively.
Materials which can be used
Solvent containing and water-dilatable enamel paints, vanishes, primers, two-component paints, clear enamels, motor-
vehicle enamels, mordants and wood preservatives.
Materials which cannot be used
Wall paints (emulsions) etc., lyes and acid containing coating materials.
Preparation of the coating material
Information regarding a sprayable dilution is normally not to be found on the material tin.
Therefore, use the viscosity table viscosity =thickness of the coating material.
Measuring the viscosity using the viscosity measuring cup (not available with all models)
1. Thoroughly stir the coating material before starting measurement.
2. Immerse the viscosity measuring cup (contents 100cm
3. Lift the viscosity measuring cup and measure the time in seconds until the flow of coating material stops.
This run-out time is called DIN seconds (DIN-s).
Viscosity table
Coating material
Solvent containing gloss paints ┈┈┈┈┈┈┈┈┈15-50
Primers ┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈25-50
Mordants┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈ undiluted
2 component paints┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈ 20-50
Clear varnishs┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈┈15-40
Water-dilutable gloss paints┈┈┈┈┈┈┈┈┈┈┈ 20-40
Motor-vehicle enamels ┈┈┈┈┈┈┈┈┈┈┈┈┈20-40
Wood preservatives ┈┈┈┈┈┈┈┈┈┈┈┈┈┈undiluted
4
) completely in the coating material below rim level and allow to fill.
3
Viscosity DIN-s
www.BormannTools.com
Explanatory diagram
1. Air cap
2. Nozzle
3. Union nut
4. Air hose
5. Spray gun
6. Material adjustment screw
7. Trigger
8. Container
9. Motor blower
10. ON/OFF switch
11. Mains cable
12. Strap