BorMann BPG9000 Manual page 3

Repairs to electrical parts should only be carried out at an authorized customer service center.

Do not use spray guns to spray flammable liquids.

Do not clean spray guns with flammable solvents.

Take precautionary measures against potential hazards from spray liquid and follow any instructions given on containers

or laid down by the manufacturer of liquid.
Do not spray any liquids of unknown hazard potential.

Keep work area clean and will lit.

Do not operate power tools in explosive atmosphere, such as in the presence of flammable liquids, gases or dust.

Keep children and bystanders away while operating a power tool.

Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed

(grounded) power tools.
Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators.

Do not expose power tools to rain or wet conditions.

Do not abuse the cord. Never use the cord for carrying, pulling or unpulling the power tool. Keep cord away from heat,

oil, sharp edges or moving parts.
When operating a power tool outdoors, use an extension cord suitable for outdoor use.

Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool

while you are tired or under the influence of drugs, alcohol or medication.
Use safety equipment. Always wear eye protection.

Avoid accidental starting. Ensure the switch is in the off position before plugging in.

Remove any adjusting key or wrench before turning the power tool on.

Do not overreach. Keep proper footing and balance at all times.

Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from moving parts.

If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and

properly used.
Do not force the power tool. Use the correct power tool for your application.

Do not use the power tool if the switch does not turn in on and off.

Disconnect the plug from the power source before making any adjustment, changing accessories, or storing power

tools.
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these

instructions to operate the power tool.
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition

that may affect the power tools operation. If damaged, have the power tool repaired before use.
Use the power tool, accessories and tool bits etc, in accordance with these instructions and in the manner intended for

the particular type of power tool, taking into account
the working conditions and the work to be performed
Have your power tool serviced by a qualified repair

person using only identical replacement parts.
Forbidden to spray to the hatch of the the motor and

etc.
When spraying normally, the motor should not be

under the head of the gun and the container
Explanation of the system
The device works according to low pressure spraying technique. A high volume of air surround the spray jet being ejected
under low pressure. The air cap provides a very fine atomization with the lowest of spray mist .The coating material is applied
to the object quickly and exactly.
Moreover, the air flow shortens the drying time for the coating material. This gives perfect spraying result with a respective
saving of coating material and is therefore good for the environment.
3
www.BormannTools.com