BorMann BPG9000 Manual page 2

Safety instructions for electric tools
Caution! Observe the following basic safety precautions when using electric tools in order to protect yourself against electric
shock, danger of injury and fire.
Read and observe these rules before using the unit.
Keep the safety instructions in a safe place.
1. Consider environmental influences
Do not expose electric tools to rain. Do not use electric tools in humid or wet environment. Provide good lighting.
Do not use electric tools near flammable liquids or gases.
2. Protect yourself against electric shock
Avoid contact with earthed objects such as pipes, radiators, stoves, refrigerators.
3. Keep your tools in a safe place
Unused tools should be kept in a dry, locked room out of the reach of children.
4. Do not misuse the cable
Do not carry the tools by the cable and do not use it to remove the plug from the socket.
Protect the cable against heat, oil and sharp edges.
5. Maintain your tools with care
Keep your tools clean to ensure good and safe operation. Follow the maintenance instructions. Check plug and cable
regularly. If defective, have them replaced by a service station or by an authorized dealer. Check the extension cable regularly
and replace it, if defective. Make sure the extension cable is equipped with the prescribed earthing contact. Keep the handles
dry and free from oil and grease.
6. Remove the mains plug
When the unit is out of use, before maintenance work and when mounting accessories.
7. Avoid unintentional start
Do not carry tools which are connected to the mains with your finger on the switch.
Make sure that the switch is off when connecting the unit to the mains.
8. Outdoor extension cable
When working outdoors only use approved and respectively marked extension cables.
Safety instructions
• Please read the operating instructions thoroughly and observe the safety instructions
• Only coating materials such as paints, enamels, varnishes, etc. with a flash point of 21°C (32° in the United Kingdom) and
above may be sprayed, without additional warming. In Germany these are coating materials in the danger classes AII and
AIII, see paint tin.
• The device may not be based in work places which are covered by the explosion protection regulations.
• When spraying, ensure that there are no sources of ignition, e.g. open fire, cigarettes, cigars, and pipes, sparks, glowing
wires, hot surfaces etc. in the area.
Recommendation: wear breathing protection when spraying.
Caution, danger of injury!
Never point the spray gun at yourself or other persons or animals.
When working with the device inside and outside care must be taken that no solvent vapors are sucked into the device.

When outdoors observe wind direction. When working indoors ensure that there is sufficient ventilation.

Do not spray at the device.

The device only splash-proof when the air hose is correctly connected.

Do not let children play with the device. Keep out of reach of children.

Care must be taken that the mains cable is not damaged. If damage is observed take immediately to an authorized

customer service center to be changed.
Remove mains plug from socket when not in use.

2
GB
www.BormannTools.com