Dejero EnGo 3x Manual page 27

www.dejero.com
Adjust the display brightness
The preferred brightness can be manually or automatically set. If you use auto adjust, the
EnGo's light sensor brightens the display in bright light and dims it in low light.
1. On the Preview screen, select
2. Select More.
3. Select Brightness.
4. Perform one of the following actions:
● To adjust the brightness manually, use the slider.
● To have the EnGo adjust the brightness automatically, select the Auto-adjust check box.
Note: For the EnGo to operate correctly, the brightness sensor on the front of the EnGo must not
be covered.
Configure the video input
You can configure the video input setting to a specific video input type, or you can select the
AUTO setting. By default, the transmitter automatically detects SDI connections, frame rate, and
resolution with this setting. If you select SDI as the input type and EnGo does not detect the
frame rate and resolution settings automatically, you can set them manually.
When you configure the video input to AUTO, it only detects SDI connections automatically. If
you want to use the IP video input, you must select it manually. With this input type, the EnGo
detects the frame rate and resolution automatically. In IP mode, only video is sent, not audio.
You cannot record clips in this mode.
Note: Before configuring the video input to IP, connect an Ethernet cable from your video source
to the EnGo. You can connect the cable to either port 1 or port 2.
1. On the Preview screen, select
2. Select More.
3. Select Settings.
4. Select Input.
5. Select Video Input.
6. Set the video input to SDI, IP, or AUTO.
7. Select Back.
8. If you selected SDI, set the Input Resolution and Input Frame Rate.
27 | Dejero EnGo 3x User Guide
.
.