Model Type Setup; Phase Setup - RadioLink A560 Instruction Manual

2.1.2 Model Type Setup

Transmitter with A560 by default is RadioLink T8FB. If it is the RTF set purchased or the
RadioLink transmitter T8FB used to work with A560 BNF version, there's no need to setup
model type. If it is other transmitter to work with A560, model type needs to be set as fixed
wing. Take AT9S as example( same as AT10II/AT10/AT9):
Steps:
Power on the transmitter-Long press Mode to enter BASIC MENU-Turn the Dial to highlight
MODEL TYPE-Press Push to enter the menu and turn Dial to select ACROBASIC-Long press
Push for 1s and a notice "ARE YOU SURE"pops out-Press Push again and a notice"Please
wait..." pops out and there will be DEE sound heard, meaning setting complete.

2.1.3 Phase Setup

Transmitter phase relates to attitude calibration and servo phase needs to be calibrated by
flight controller(this step can be skipped for A560 RTF version).
Steps:
Long press Mode to enter BASIC MENU - rotate Dial to highlight REVERSE-Press Push to
enter the menu-rotate Dial to highlight 3:THRO -change NOR to REV-press Push to confirm
'ARE YOU SURE?'
[MODEL TYPE]
RESET: Execute
TYPE:ACROBASIC
AILE-2: CH6or7
ATL: OFF
[REVERSE]
CH3:THRO
REV NOR
CH9: NOR
CH10: NOR
CH11: NOR
CH12: NOR
1:AILE NOR
2:ELEV NOR
3:THRO REV
4:RUDD NOR
5:GEAR NOR
6:FLAP NOR
7:AUX1 NOR
8:AUX2 NOR
5
RadioLink Electronic Ltd
www.radiolink.com