RadioLink RC4GS V3 Instruction Manual page 17

RadioLink Electronic Limited
www.radiolink.com
OFF: Speed1 or speed2 can be selected.
OFF means shut down the throttle speed
function
Adjustment method for SPEED1
Setup items
MODE: Speed type selection
ALL: Speed adjustment
Adjustment range
0~100 (each direction)
At 100, there is no delay
(1) Enter the function menu and use "Dec(-)"or"Inc(+) " button to access THSPD function.
(2) Press "Enter" button to get into THSPD function interface.
(3) If initial MODE setup item is SPEED1, {if initial MODE setup item is SPEED2 or OFF, you need to select
SPEED1 by pressing"Dec(-)" or "Inc(+)"button to select MODE setup item , then press "Enter" key, SPEED2
or OFF will blink, press "Dec(-)" or "Inc(+)" button, when the blinking SPEED 2 or OFF change to blinking
SPEED 1, press "Enter" key, SPEED1 will stop blink, now SPEED1 is selected}, press "Dec(-)" or "Inc(+)"
button to select ALL setup item, then press"Enter" key, the initial value will blink, use"Dec(-)"or"Inc(+)" button
to adjust the delay of the entire throttle forward side range.
(Note: In the interface of adjusting the value, return to the initial value "100" by pressing "Dec(-)" and "Inc(+)"
buttons simultaneously for about 1 second.)
Press "Enter" button, the adjusted value stops blinking, now the value has been set.
(4) When ending setting, return to the initial screen by pressing "Exit" button twice.
Adjustment method for SPEED2
Setup items
MODE: Speed type selection
LOW: Low side range speed adjustment
HIGH: High side range speed adjustment
TGP1: Low and medium speed switching point
Adjustment range
LOW: 0~100
HIGH: 0~100
At 100, there is no delay
TGP1: 0~100
(1) Enter the function menu and use "Dec(-)"or "Inc(+) " button to access THSPD function.
(2) Press "Enter" button to get into THSPD function interface.
(3) If initial MODE setup item is SPEED 2, {if initial MODE setup item is SPEED 1, you need to select
SPEED2 by pressing "Dec(-)" or "Inc(+)" button to select MODE setup item, then press "Enter" key, SPEED1
or OFF will blink, press "Dec(-)" or "Inc(+)" button, when the blinking SPEED1 or OFF change to blinking
SPEED2, press "Enter" key, SPEED2 will stop blinking, now SPEED2 is selected}, press "Dec(-)" or "Inc(+)"
button to select "LOW" or "HIGH" delay adjustment or"TGP1" speed switching point adjustment.
(4) Press "Enter" key to confirm "LOW" or "HIGH" or "TGP1" setup item, and the value of your selected
16