7.
Observe the analyzer for the results of the adjustment routine:
If the analyzer displays Option Cor DOME, you have completed this
n
procedure.
If the analyzer has more than one option, repeat steps 3 through 6 to
n
8. If no more correction constant routines are going to be performed, return the
1. If the analyzer dlsplays Option Cor FAIL, check the keyword used in step
2 and make sure it ls correct. Pay special attention to the letters "1" or "O",
the numbers "1" or "0" (zero). Repeat this entire adjustment test.
2. If the analyzer continues to fall the austment routine, refer to the "Dlgltal
Control Troubleshooting" chapter.
and Correction Constants