Agilent Technologies HP 8719D Service Manual page 467

DSP ALU, lo-13
DSP Control, lo-13
DSP Intrpt, lo-13
DSP RAM, lo-13
DSP Wr/Rd, lo-12
E
EDIT, 10-8
edit list menu, 10-8
equipment
display intensity correction
constants adjustment, 6-14
EEPROM backup disk procedure,
3-36
fractional-N spur avoidance and
FM sideband adjustment, 3-49
frequency accuracy adjustment,
3-45
IF amplifier correction constants
adjustment , 3-13
equipment for service, l-l
error
BATTERY FAILED. STATE MEMORY
CLEARED, lo-41
BATTERY LOW! STORE SAVE REGS
TO DISK, lo-41
CALIBRATION ABORTED, lo-42
CALIBRATION REQUIRED, lo-42
CORRECTION CONSTANTS NOT
STORED, lo-43
CORRECTION TURNED OFF, lo-43
CURRENT PARAMETER NOT IN
CAL SET, lo-43
DEADLOCK, lo-43
DEVICE: not on, not connect,
wrong addrs, lo-44
DISK HARDWARE PROBLEM,
DISK MESSAGE LENGTH ERROR,
DISK: not on, not connected, wrong
addrs, lo-44
DISK READ/WRITE ERROR, lo-45
INITIALIZATION FAILED, lo-46
INSUFFICIENT MEMORY, PWR
MTR CAL OFF, lo-46
NO CALIBRATION CURRENTLY IN
PROGRESS, lo-46
NO IF FOUND: CHECK R INPUT
LEVEL, lo-47
NO SPACE FOR NEW CAL. CLEAR
REGISTERS, lo-47
NOT ALLOWED DURING POWER
METER CAL, lo-48
NOT ENOUGH SPACE ON DISK
FOR STORE, lo-46
OVERLOAD ON INPUT A, POWER
REDUCED, lo-48
OVERLOAD ON INPUT B, POWER
REDUCED, lo-48
OVERLOAD ON INPUT R, POWER
REDUCED, lo-49
PARALLEL PORT NOT AVAILABLE
FOR COPY, lo-49
PARALLEL PORT NOT AVAILABLE
FOR GPIO, lo-49
PHASE LOCK CAL FAILED, lo-50
PHASE LOCK FAILURE, lo-47
PHASE LOCK LOST, lo-50
POSSIBLE FALSE LOCK, lo-50
POWER METER INVALID, lo-51
POWER METER NOT SETTLED,
10-51
POWER SUPPLY HOT!, lo-52
POWER SUPPLY SHUT DOWN!,
POWER UNLEVELED, lo-51
PRINTER: error, 10-52
PRINTER: not handshaking, lo-52
PRINTER: not on, not connected,
wrong addrs, lo-52