Connect Power To A Pa-1400 Series Firewall - PaloAlto Networks PA-1400 Series Hardware Reference Manual

Connect Power to a PA-1400 Series Firewall

Connect Power to a PA-1400 Series Firewall
The following procedure describes how to connect AC power to a PA-1400 Series firewall with
AC power supplies.
Learn how to Set Up a Connection to the Firewall
powering on the firewall for the first time.
To avoid injury to yourself or damage to your Palo Alto Networks
that resides on the hardware, read the
STEP 1 | Remove the nut and star washer from the ground stud on the back of the firewall.
STEP 2 |
Crimp a 14AWG ground cable to a ring lug (cable and lug not included) and then attach the
ring lug to the ground stud on the firewall. Replace the star washers and nuts and torque to
25 in-lbs. Connect the other end of the cable to earth ground.
STEP 3 | Connect the AC power cord to the power input on the back of the firewall.
PA-1400 Series Next-Gen Firewall Hardware Reference
based on your desired boot mode prior to
Product Safety Warnings.
28
hardware or the data
®
2022 Palo Alto Networks, Inc.
©