PaloAlto Networks PA-1400 Series Hardware Reference Manual page 27

Connect Power to a PA-1400 Series Firewall
STEP 4 | Power on the firewall. See
connect power to the firewall.
• (Standard mode) Using your terminal emulator, watch for the following CLI prompt as the
firewall boots:
Do you want to exit ZTP mode and configure your firewall in
standard mode (yes/no)[no]?
Enter yes. The system will then ask you to confirm. Enter yes again to boot in standard
mode.
If you miss the above CLI prompt, you can also change your boot mode using the
web interface. Go to the firewall login screen at any point before or during the
startup process. A prompt will ask if you wish to continue booting in ZTP mode or if
you would like to switch to standard mode. Select Standard Mode and the firewall
will begin rebooting in standard mode.
• (ZTP mode) Stand by as the firewall boots up.
STEP 5 | Set up the firewall manually if using standard mode. If using ZTP mode, the device group
and template configuration defined on the Panorama management server are automatically
pushed to the firewall by the ZTP service.
• (Standard mode) Change the IP address on your computer to an address in
the 192.168.1.0/24 network, such as 192.168.1.2. From a web browser, go to
https://192.168.1.1. When prompted, log in to the web interface using the default
username and password (admin/admin).
• (ZTP mode) Follow the instructions provided by your Panorama administrator to register
your ZTP firewall. You will have to enter the serial number (12-digit number identified as
S/N) and claim key (8-digit number). The claim key is required to
Panorama management
device.
PA-1400 Series Next-Gen Firewall Hardware Reference
Connect Power to a PA-1400 Series Firewall
server. These numbers are stickers attached to the back of the
27
to learn how to
add a ZTP firewall to the
2022 Palo Alto Networks, Inc.
©