Table of Contents
Advertisement
Appendix E – Battery Replacement Procedure
4. Isolate the old battery by disconnecting the CN5 connector.
Figure E.2 – CN5 Connector
5. Uninstall the old battery by removing the screws as shown below.
6. Install the new battery.
7. Connect the new battery to the CN5 connector.
Figure E.3 – Rajamane Battery
8. Reconnect the UPS/power supply module to the INFORMA PMD-A 3U device.
9. Connect the power cord and switch on the INFORMA PMD-A 3U device.
199
www.qualitrolcorp.com
Advertisement
Table of Contents
