Table of Contents
Advertisement
Getting Started
Getting Started
Examples
Wiring Information
Making a Back Up System Image
28 Test System Installation
The Agilent TestExec SL software is pre-installed on your PC controller's
hard drive. Agilent TestExec SL allows you to create testplans to control
instruments and switching. Start TestExec SL from this icon in the PC
desktop:
You can also run TestExec SL by clicking:
Start | Programs | Agilent TestExec SL 5.1 | TestExec SL 5.1
The TS-5400 Online Help contains getting started examples for E22xxA
systems. To access the getting started examples, from TestExec SL, click:
Tools | TS-5400 Online Help
The help file opens up to a selection of getting started examples. Click the
link that corresponds to your system.
An "E22xxA Wiring and Hardware Reference Guide" is included with your
system. This guide shows you how to make connections to the system's Test
System Interface. This manual is also available from Test Exec SL by
clicking:
Tools | TS-5400 Online Manuals
This opens a directory of all online manuals. Click the appropriate link to
access the wiring guide for your system.
Agilent STRONGLY recommends you use a tool such as Symantec Ghost
(not supplied with the system) to make a back up image of your system
software. You should make a back up now, immediately after installing the
system, and periodically as time goes on to capture any development efforts
and software changes. Having a back up image greatly simplifies the process
of system recovery following such catastrophic events such as a hard disk
crash. With Symantec Ghost you can make a complete duplicate image of
the OS and software on your system. Back ups can be made to a network
shared drive or to the system DVD writer.
Chapter 2
Advertisement
Table of Contents
