Preparing The Fuser - Lexmark W820dn Setup Manual
Lexmark w820dn: install guide
Hide thumbs
Also See for W820dn:
- Reference manual (475 pages) ,
- User manual (333 pages) ,
- Quick reference (2 pages)
Table of Contents
Advertisement
Note:
screwdriver for the following steps.
20
Set up printer supplies
Preparing the fuser
You need a coin or a flat blade
8
Carefully pull the yellow tape
completely out of the cartridge.
Discard the tape.
9
Close the front door (Door F).
Door F
The fuser supports approximately
300,000 pages of single-sided printing.
The printer displays a message when it
is time to replace the fuser. Refer to the
publications CD for details.
You must remove the two metal screws
on each side of the fuser before
operating the printer; otherwise, print
quality will be diminished.
Advertisement
Table of Contents
