Attaching The Cables - Lexmark W820dn Setup Manual

CAUTION!
turned off and unplugged before
continuing.
Transport unit cable
Power cable
66
Set up the optional finisher

Attaching the cables

Make sure the printer is
Communication cable
Three cables come with the finisher: two
of the cables connect the finisher with
the printer and one cable is pre-attached
to the transport unit.
1
Attach one end of the
communication cable to the
middle connector on the finisher.
Tighten the thumbscrews to
ensure a good connection.
2
Attach the other end of the
communication cable into the
middle connector labeled "Output"
on the printer.
3
Attach the transport unit cable to
the top connector on the finisher.
Tighten the thumbscrews to
ensure a good connection.
4
Attach one end of the power cable
to the bottom connector on the
finisher.
5
Attach the other end of the power
cable into the electrical connector
on the side of the printer.