Basic Procedures For Sending Faxes - Canon 5119B001AA Basic Operation Manual

Basic Procedures for Sending Faxes

This section describes the basic procedure for sending a fax.
1
Place your documents.
"Placing Documents" (→P.2-4)
"Supported Document Types" (→P.2-2)
2
Press [
3
Specify the scanning settings as needed.
There are the four items you can specify.
(For details, see P.6-3 to P.6-4.)
Resolution Settings
Density Settings
2-Sided Original (MF8380Cdw Only)
Sharpness Settings
The settings specified here are effective only for the
current sending operation. To make the settings
effective for all the fax operations, see "Changing the
Default Fax Settings" (→P.6-22).
6-2
].
4
Specify the destination.
These are the following methods to specify a destination.
(For details, see P.6-5 to P.6-6.)
Entering the fax number
Address book
Coded dial codes
5
Press [ ] (B & W).
When your fax is placed in the feeder
The scan starts. Your fax is sent to the destination when the scan is
complete.
When your fax is placed on the platen glass
Perform the following procedure.
(1) Select the size of the original document using [
press [OK].
Scan Size
LTR
STMT
(2) Place the next page on the platen glass and press [
Press [ ] (B & W) for each page.
(3) When all documents are scanned completely, select <Start
Sending> using [ ] or [
Your fax is sent to your fax destination.
Group dialing
S equential broadcast
(→P.6-11)
] or [ ] and
] (B & W).
] and press [OK].