Keep Alive Time - Lexmark X644E User Manual

Keep Alive Time

T :
IP
Set this option to as big a value as possible. Be
sure it is smaller than the session's inactivity
timeout value defined on the host. This will help
minimize network traffic.
Operations - TN5250E SETUP: CONNECTION # > SERVER # INFO > Keep Alive Time
This Connection# > Server# Info option specifies the time in sec-
onds that expires between each keep alive signal sent to the host.
The Keep Alive Type setting specifies the type of signal sent to the
host.
If the Keep Alive Type
setting is ignored. If Telnet NOP or Timing Mark was selected, set
this option value to a value less than the
host.
Option Value Comments
45 * [1..32000] The range is 1 to 32000 seconds.
signal setting is set to None, this option value
INACTTIMO
value on the
170