Lexmark X644E User Manual page 66

Option Default Value
Device # Name
[undefined]
Keep Alive Type
None
Keep Alive Time
45 seconds
MSGQ # Name
QSYSOPR
MSGQ # Lib
*LIBL
IR # Reply
Normal
AS/400 and iSeries Installation Setup: Task 4 - Configuring the SCS/TNe Emulation
Recommended Value Comments
Your device name The host will autoconfigure a device and writer with this
(up to 10 characters) name if it does not exist.
None Leave this at the factory default if the host is configured to
send a keep alive signal.
Choose a different setting to have the SCS/TNe
or own preference
Emulation send a keep alive signal.
Your own preference This setting is not used if the
(1-3200 seconds) value is set to None (= disabled).
If you have chosen to enable a
set this value to a value smaller than the INACTTIMO
defined on the host.
Your preferred Specifies the message queue name to which IR replies
queue name (up to are reported. This name must already exist on the host. It
10 characters) will not be auto configured. Contact your system adminis-
trator if you do not know the message queue name.
The library name of Specifies the library of the message queue name set with
the message queue the
(up to 10 characters) on the host It will not be auto configured. Contact your
system administrator if you do not know the library name.
Normal Leave this option at its default value to have printer inter-
vention required conditions reported to the host.
MSGQ # Name option. This library must already exist
Keep Alive Type option
Keep Alive Type
66