Chain Lock Adjustment, Different Chain Types - Markusson combiMatic User Manual

CHAIN LOCK ADJUSTMENT, DIFFERENT CHAIN TYPES

The lock adjustment is placed to the right. This is used to change the locking point on the
chain ruler when grinding different types of chains.
To change the locking point: stop the machine when the chain is "free". Loosen the plastic
nut (1) and move the lever either to 404 / 3/8 / .325 (position 1) or to 3/4 (position 2).
When this is done the spacers between the rulers needs to be fitted as shown below. When
delivered the spacers are fitted for position 2. Loosen the outer chain ruler, fit spacers as
shown below and the re-fit the ruler.
NOTE!
When changing the locking point, the lever must be positioned in either

– chain size 404 / 3/8 / .325 or Pos
Pos
positioned in between Pos
down.
Position
1: Plastic nut
2. Spacer 6 x10x2,5 (x4)
5. Lever

and Pos


– chain size 3/4. The lever must not be

as this might cause the machine to break
11

Position
1: Plastic nut
3. Spacer 6 x10 x 4 (x4)
4. Spacer 10 x40 x 3 (x2)
5. Lever