GRINDING WHEEL ADJUSTMENT DEPTH
It is possible to adjust the position of the grinding motor turning the knob on the front of
the grinding head. An arrow indicates a number on a scale. This adjustment is used as the
diameter of the grinding wheel decreases when it is worn.
When fitting a new grinding wheel, the arrow should point at 1-3 on the scale. As the
wheel is worn, it should be adjusted to a higher number making sure that each tooth is
equally deep.
STROKE ADJUSTMENT
The stroke adjustment (distance between to teeth) is done with the wing-nut on top of the
machine. Loosen the nut and position it according to the label. This must be changed if
chains with different pitch are grinded, for example 3/4 to 404. It is important the the
feeder arm stops right above the rivet behind the cutting link. Se pictures below.
NOTE: Not to be mixed up with the cutting tooth length setting.
14